Why 18" Tire pressure--->36F, 39R

4wheelpilot

Active Member
Joined
Apr 1, 2018
Messages
151
Reaction score
36
Points
28
Location
Bucks County, Pennsylvania
I've driven a lot of cars over the years and I've never seen a car with a square set up (same size/aspect tires all around) with different recommended cold tire pressures front to rear.
Does anyone know why Kia recommends 36F but 39R pressures?

And while I'm at it, if you're not running 36F/39R, what cold pressures do you run and why?
 
The 19s are reco'd 38 F and 36 R , yes I doubled checked !
 
Maybe because of weight distribution of the car?
 
This isn't my first car with different recommended pressures front and back. But I can note that the word used is "recommended". In autocross, there's a common practice of marking your tires' sidewalls with a "crayon" of sorts so that when you come off the course you can see how much your tires are rolling over. Once a tire rolls over far enough to pass the edge of the tread, you know it's underinflated for your use - time to add some air.

Also, an overinflated tire mostly has the center of it's tread wearing on the road as the tire is more rounded. An underinflated tire will show more wear on the edges as the center of the tread can deflect away from the road - inside the tire, more or less. When someone inspects a tire for wear, these are the things that can be seen. Someone's (hopefully) done enough studying of the tires' performance with whatever they consider "normal" use and come up with these pressures.

In the case of 18" vs. 19", they are completely different tires. So I don't find it surprising at all that the recommendations are different. I'd be surprised if they weren't!

Similarly, using different tires, or even different dimensions (ratio, tread width) of the same tire will very likely require different numbers.

This is why it's a good practice to check your tires when they're rotated so that you can see if you're habitually under- or over-inflating any tires based on your own tire/wheel setup and driving style.
 
From interior to exterior to high performance - everything you need for your Stinger awaits you...
As the OP, I asked about the 18” tires only. I wasn’t asking about comparing 18 to 19, nor different widths/aspect ratios. And of course cyclocross is a specialized situation placing atypical stresses on tires. My post is based on the unusual recommended front and rear cold tire pressures that are different and the fact that I have never seen this in any other car with square set up. Does anyone have an explanation?
 
As the OP, I asked about the 18” tires only. I wasn’t asking about comparing 18 to 19, nor different widths/aspect ratios. And of course cyclocross is a specialized situation placing atypical stresses on tires. My post is based on the unusual recommended front and rear cold tire pressures that are different and the fact that I have never seen this in any other car with square set up. Does anyone have an explanation?
I don't have a "why" but I have had two cars in the past with square setups that recommended more air on the axle where the wheels were driven. 32F 30R on a FWD car and 36F 39R on a RWD car. I would just be conjecturing on why, but it does happen on other cars.
 
Ok. Which cars were they?
Maybe someone can explain this about the square set up on the AWD Stinger.
Pontiac G8 GT and Chevy Equinox were the two cars I was referring to. And now that I think back, the Equinox was AWD, but heavily FWD-biased, up to 100 percent front. There is a little more info in the manual about tire pressures, too, if that is of interest to you.
 

Attachments

  • Capture.webp
    Capture.webp
    32 KB · Views: 28
My 2 pennies: RWD requires more pressure on the rear tires. Same goes for AWD as AWD in the Stinger isn't a 50/50 balance, it's more like 40F/60R in normal circumstances and for long drives on a normal road where AWD isn't required, you'll be driving RWD
 
______________________________
From interior to exterior to high performance - everything you need for your Stinger awaits you...
FWD Fiesta ST had higher pressures in the front per sticker/manual.
 
Weight distribution possibly? :)... Again
 
Let's assume someone is going on a road trip with two 100lb teenagers and a 50lb kid in the back. They fill up the car with 16 gallons of fuel at roughly 7lbs per gallon. Finally they throw 75lbs of luggage/gear/strollers in the hatch.

They've placed an extra 430+ lbs onto the rear tires. The extra PSI (my guess) is to compensate for the extra amount of weight that is likely to be put in the rear of the car.
 
The cars I've owned the last 5 years had varying front and back pressure. This is the first however that more is needed in the front.
 
This is the first however that more is needed in the front.

The recommended pressure for the 19" tires is 36 front and 38 rear.
For 18" tires it's 36 front and 39 rear.

Neither setup requires more PSI in the front than rear.

2018-Kia-Stinger-sedan-recommended-tyre-pressure.JPG
 
From interior to exterior to high performance - everything you need for your Stinger awaits you...
Well then mine is a unicorn?

20180530_174545.webp
 
______________________________
Ya know what's crazy? Mine is different than the one you posted AND the one I posted earlier (found on a website). I think the first pic I posted is from a different car, maybe a Cadenza.

I wonder if AWD/RWD makes a difference.

Anyway, mine says 36 psi for both front and rear.

WNM7NpC.jpg
 
LOL

Oh, man, it's a conspiracy!
 
LOL

Oh, man, it's a conspiracy!
No conspiracy, but there is a difference for AWD/RWD on 19 inch tires. You can see the chart from the manual I posted above.
 
Back
Top