Seeking How To How to remove stock & install aftermarket exhaust tips?

[stingerwanter]

Hello all, I'm currently running stock exhaust tips and want to install these that I bought which I'm about to get powder coated black:

For Sale - 4 Exhaust tips $120 (63mm inlet 105mm outlet)

Selling 4 exhaust tips since I’m not in the market right now for one. Picked these up after getting my stinger and never got around to my exhaust. Never opened and brand new. Paid $90 for all four from Ali express. I’ll do $120 for all four exhaust tips. Size 63mm in and 105mm out. Wanted to...

stingerforum.org

I am trying to figure out how to remove the stock tips and install these. I can't even seem to figure out how the stock ones are attached to the bumper piece. Do I need ramps/a jack?

 

[bfglitch]

Check out this post. Exhaust Tips

 

[stingerwanter]

Check out this post. Exhaust Tips

Thanks! Wow that looks like kinda a pain in the ass.

 

[AusStinger]

I got the back up as high as I could and removed the rear mufflers ( 4-5 bolts each side ) and then removed the OEM tips ( 4 screws ), reinstalled the mufflers, then installed the new tips.

 

[Rodtheviking]

This is what I did.

 

[Deviate]

Man

This is what I did.

Man that seems like a lot of work to me. I hadn't seen that vid before.
I did the same as @AusStinger and quick dropped my mufflers. The little screws on top of the stock tips, I used a 1/4" drive bit and a ratcheting box wrench to loosen to the point where i could get them out by hand. Really wasn't bad at all.

 

[Pearly]

I got the back up as high as I could and removed the rear mufflers ( 4-5 bolts each side ) and then removed the OEM tips ( 4 screws ), reinstalled the mufflers, then installed the new tips.

View attachment 77200

View attachment 77201

View attachment 77199

What exhaust setup is this???

 

[AusStinger]

What exhaust setup is this???

What's in the picture is the Australia only, series 1 Bi-Modal mufflers.
In front of that I'm running with JUN BL.