Pull fuse.. Brake boost?
- Thread starter Stingboy
- Start date
SneakerB
Active Member
- Joined
- Sep 10, 2021
- Messages
- 396
- Reaction score
- 99
- Points
- 28
yea it works but if your awd it turns your car into rwd. another member helped me build a fuse switch that i could just press a button and it would disable that fuse. its not really worth it either way unless you have slicks because you just spin....
G
G-497198
I have a rwd . Would it work ?
______________________________
SneakerB
Active Member
- Joined
- Sep 10, 2021
- Messages
- 396
- Reaction score
- 99
- Points
- 28
Yes u have to pull the fuse after the vehicle is on or it wont start! I also think the brake lights stop working so kee that in mind!
It's the stop lamp fuse in the driver side dash fuse panel. It does not turn AWD to RWD, that would be the AWD fuse in the engine bay fuse panel. Pulling the stop lamp fuse will allow you to build boost for launching. Like mentioned, you have to disconnect it with the vehicle on so it's best to install a switch to turn it off and on.
From interior to exterior to high performance - everything you need for your Stinger awaits you...
In the fuse panel under the driver side dash. "Stop lamp" fuse. Making and installing a switch is HIGHLY recommended.
SneakerB
Active Member
- Joined
- Sep 10, 2021
- Messages
- 396
- Reaction score
- 99
- Points
- 28
It did to mine!
The yellow part is called a "fuse socket connector" pretty sure the size is micro2
Attachments
From interior to exterior to high performance - everything you need for your Stinger awaits you...
The new brake snip?
So heres how i did it and so far it works great. i took small gauge wire added 2 ferrules crimped and flattened with a hammer to fit in the fuse slot. 1 wire just has ferrule and a female connector plugged into toggle switch purchased from amazon. The other wire I have ferrule, soldered inline...
stingerforum.org
