ht_addict
Stinger Enthusiast
I took my car in to get the film coating as well as Windows tinted couple weeks ago. Had to take it back for some touch ups. When I picked up my car I was just about to make a right turn out of the parking lot when I looked left to check for traffic and notice a hole on the top of the indoor panel in the grey portion just above the door handle inside the car. I immediately turned back in and brought it to there attention. Of course they said it was there when dropped off, which is BS. They had a picture to prove. Again BS. Can be taken after the fact. I have had the car for 4weeks, no need to clean inside yet or apply protectant to interior. If I rest my hand on the window ledge when open my fingers, wrist come no where near the hole. I asked to see the tools they use and I guarantee it was the squeegee they use that did it. The penetration of the hole and pushing up of material indicates a motion from centre to outer edge of window which would be fine when removing moisture under film during application. I'm still waiting to hear back on what they are going to do even though they deny they did it, so looking for solutions if I have to fix myself.

