3.3TT Mishimoto Cold Pipe and BMS WMI Sytem Install Questions

[Anden L Schmitt]

So the mishimoto cold pipe comes with a spot that is for a WMI line but Its not fully drilled out from the looks of it, what do I need to do in order to install the WMI line from the BMS Stealth Kit to the Cold pipe?

 

[Houstinger1]

I have the same setup. You can just tap out the hole. Be sure to get the piece that falls out into the cold pipe.

 

[Anden L Schmitt]

I have the same setup. You can just tap out the hole. Be sure to get the piece that falls out into the cold pipe.

Tap it out with what?

 

[STINGER]

Tap it out with what?

The WMI nozzle uses a 1/8NPT thread size, you will need to remove the charge pipe if installed and drill it then use a thread tap to create a thread. If you haven't done something like this before then I suggest to take it to a shop to do it.

Amazon.com: GlowShift 1/8-27 NPT Drill & Tap Kit - 1/8" Carbon Steel Tap & R High Speed Steel Drill Bit for EGT Probe Installation to Exhaust Manifold: Toys & Games

Buy GlowShift 1/8-27 NPT Drill & Tap Kit - 1/8" Carbon Steel Tap & R High Speed Steel Drill Bit for EGT Probe Installation to Exhaust Manifold: Tools & Equipment - Amazon.com ✓ FREE DELIVERY possible on eligible purchases

www.amazon.com

 

[Anden L Schmitt]

The WMI nozzle uses a 1/8NPT thread size, you will need to remove the charge pipe if installed and drill it then use a thread tap to create a thread. If you haven't done something like this before then I suggest to take it to a shop to do it.

Amazon.com: GlowShift 1/8-27 NPT Drill & Tap Kit - 1/8" Carbon Steel Tap & R High Speed Steel Drill Bit for EGT Probe Installation to Exhaust Manifold: Toys & Games

Buy GlowShift 1/8-27 NPT Drill & Tap Kit - 1/8" Carbon Steel Tap & R High Speed Steel Drill Bit for EGT Probe Installation to Exhaust Manifold: Tools & Equipment - Amazon.com ✓ FREE DELIVERY possible on eligible purchases

www.amazon.com

I've done this before, just didnt know it was that simple lol.

Are you sure its 1/8? @Terry@BMS told me it was 1/4

 

[AWDGT2]

I think the 1/4 NTP is for the bung that goes into the bottom of the plastic tank.

 

[STINGER]

Are you sure its 1/8? @Terry@BMS told me it was 1/4

I have spoken