Kiteflygolfdrive
Active Member
- Joined
- Dec 21, 2021
- Messages
- 128
- Reaction score
- 121
- Points
- 43
Installed the front and rear eibach bars today. I was able to properly torque all the nuts/bolts to the proper specs based on the chart in this thread except the PITA drivers side bolt. We actually removed that nut in just a few minutes. Getting that nut back on was a whole different story Due to the design of the Eibach bushing and clamp. The angles sides make it difficult to use a ratchet of any kind other that a smalll 3/8. I couldn’t get a torque wrench on it properly even after removing the wheel liner and moving the fuel lines and an inch to the left. I just got it as tight as possible with a ratchet. Car feels great. I used the provided grease and added Teflon tape. After installation I used a grease gun to add a bit more via the zerk fitting. Thanks for the help.
